The Jumbo Nose Guard is designed to fit Stand Up Paddle (SUP) and big longboards with full thick (1 1/2 inch to 3 inch) nose shapes. For thinner (1/2 inch to 1 inch) nose shapes, the Longboard Nose Guard is recommended.
The Nose Guard functions as a soft "shock absorbing guard" that protects the nose of the board and you from dings. The Nose Guard will not affect board performance.
Easy to Apply Instructions
1. Clean nose area of wax, sand, dust, etc. Use isopropyl alcohol if necessary. With sandpaper included in kit, lightly sand the nose tip section that will be covered by the Nose Guard. Wipe off dust with a clean rag or paper towel.
2. Tear open Nose Guard primer pouch, exposing the towelette. Keep towelette in pouch and wipe primer onto the entire area that will be covered by the Nose Guard.
3. Peel off liner inside Nose Guard. Spread open Nose Guard and line up center "V" slot on Nose Guard with the center of the board. Be sure Nose Guard logo is facing deck side.
4. Carefully align and press the rest of the Nose Guard on to the board. Firmly press the Nose Guard to remove any bubbles or wrinkles.
THAT'S IT! Your board can immediately be taken into the water! The Nose Guard will not come off with proper application and normal use.
The Jumbo Nose Guard fit perfectly on my WakeSUP 17 . Only wish I would have got it BEFORE I dinged up the nose :o)
The nose guard went on easily. Now my board is protected from sneaky, unwanted hard stuff!